Intended Use; Symbols - Renkforce DL-LED107S Mode D'emploi

2. Intended Use

The LED PAR Light is used to generate light effects in light show equipment, party rooms, etc. and is con-
trolled by the built-in controller or an external DMX controller.
This product is only approved for connection to 100-240 V/50/60 Hz alternating current and only for use with
an earthed mains socket.
The DMX connections must only be connected to suitable DMX controllers or other DMX devices.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
Any use other than that described above will damage this product and involves the risk of short circuit,
fire, electric shock, etc.
The entire product must not be modified or converted, and the casing must not be opened.
Observe all safety and assembly notes in these operating instructions!

3. Symbols

This symbol on the device indicates that the user must read these operating instructions before
using the product and observe them during operation.
The symbol with a lightning bolt in a triangle is used where there is a health hazard, e.g. from
electric shock. The device contains no parts that require servicing by the user. Therefore, never
open the device.
The arrow symbol indicates special advice and operating information.
The exclamation mark indicates important notes in these operating instructions that must be
strictly observed.
This symbol indicates the minimum distance to the illuminated surfaces.
...m
18