Setting Up A Master Slave Chain; Mains Connection - Renkforce DL-LED107S Mode D'emploi

b) Setting up a Master Slave Chain
The effect light can be operated controlled by a DMX controller or in a master slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• Connect the DMX OUT port of the master device to the DMX IN port of the first slave device.
• Connect the DMX OUT port of the first slave device to the DMX IN port of the subsequent slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT connection of the last slave device (as
described in section "Connection of a DMX controller").

8. Mains Connection

The mains socket to which the effect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause po-
tentially fatal electric shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Never overload the mains output POWER OUTPUT. The max. resilience of the mains output is
indicated in the device's labels. The maximum consumption of all connected devices must not
exceed this value.
• Connect the mains connector of the mains cable into the mains connection POWER INPUT at the de-
vice.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, it takes up operation.
• Through the mains output POWER OUTPUT, other effect beamers can also be connected to the mains.
For this, plug in a mains extension (available in specialist stores) in the mains output POWER OUTPUT
and connect it to the mains connection of another device.
23