Setting Up A Master-Slave Chain; Mains Connection - Renkforce DL-PAR105 Mode D'emploi

b) Setting up a master-slave chain
The effect light can be operated controlled by a DMX controller or in a master-slave chain. In that case, the
integrated controller of the master device controls the connected slave devices.
• Connect the DMX OUT port of the master device to the DMX IN port of the first slave device.
• Connect the DMX OUT port of the first slave device to the DMX IN port of the subsequent slave device.
• Proceed as described above with all remaining slave devices.
• Plug an XLR plug with a terminating resistor into the DMX OUT connection of the last slave device (as
described in section "Connection of a DMX controller").

9. Mains connection

The mains socket to which the effect light is connected must be close to the device and easily
accessible to quickly separate the device from the mains voltage in case of an error.
Ensure that the voltage indication on the effect light matches the mains voltage of your power
supply. Never try to operate the device with any other voltage.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause
potentially fatal electric shock.
Make sure that no cables are lying around openly. Install cables professionally to prevent ac-
cidents.
Never overload the mains output POWER OUT. Up to 7 same devices can be connected here.
Never connect other devices or more devices than indicated here. This would cause overload
of the POWER OUT connection.
• Connect the mains connector of the mains cable to the mains connection POWER IN at the device.
• Plug the mains plug of the mains line into a grounded socket.
• Once the device is connected to the mains socket, the display lights up.
• Through the mains output POWER OUT, up to 7 other effect beamers of the same type can be connected
to the mains. For this, plug a mains extension (available in specialist stores) into the mains output POWER
OUT and connect it to the mains connection POWER IN of the next device.
32