Handling; Disposal; Technical Data - Renkforce DL-LED107S Mode D'emploi

11. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device. Allow the device to reach
room temperature before connecting it. Wait until the condensation has evaporated.
• Never plug in or unplug the mains plug when your hands are wet.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Unplug the mains plug from the mains socket if you are not using the device for an extended period of
time.
• Disconnect the mains plug from the mains socket in thunderstorms for reasons of safety.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any
objects like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0,5 m
around the device.

12. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of its service
life.

13. Technical Data

Operating voltage...............................................100-240 V/50/60 Hz
Power consumption...........................................13 W
Fuse ......................................................................F1AL/250V (5 x 20 mm)
Operating modes . ...............................................DMX / auto / master-slave / sound-to-light
LEDs......................................................................108 LEDs 10 mm
DMX protocol......................................................DMX 512
DMX channels ....................................................3 / 6
Dimensions..........................................................180 x 180 x 90 mm
29