Reset; Focussing; Handling - Renkforce S1 Moving Head à DEL Notice D'emploi

h) Reset
In case of function interferences, you may need to restart the moving head. For this, perform the following
steps.
• Select rSt in the menu.
• Press the ENTER button (6) to confirm your input.
• The internal controller restarts the moving head. During starting, the message rST is displayed.
i) Focussing
• Adjust the sharpness of the projection as desired by turning the projection lens at the lens.

12. Handling

• Never connect the mains plug to a mains socket immediately after the device has been taken from a cold
to a warm environment. The resulting condensation may destroy the device. Allow the device to reach
room temperature before connecting it. Wait until the condensation has evaporated.
• Never pull the mains plug from the mains socket by the cable. Only pull it from the mains socket by the
intended grip areas.
• Always pull it from the socket using the intended grips.
• Disconnect the mains plug from the mains socket during thunderstorms for reasons of safety.
• Never put any filter foils, masks or other materials over the light exit. This may cause heat damage and
danger of fire.
• The device may heat up during operation. Never touch the casing during operation. Let the effect light
cool off after operation before touching or cleaning the casing.
• Do not cover the device to ensure sufficient ventilation. Air circulation also must not be impaired by any
objects like magazines, tablecloths, curtains, etc. During operation, keep a minimum distance of 0.2 m
around the device.
38