Use With Dmx Controller - Renkforce S1 Moving Head à DEL Notice D'emploi

b) Use with DMX Controller
Each DMX device in a DMX chain requires a so-called DMX starting address to be clearly identified by the
controller. This DMX starting address specifies the first DMX channel to which the effect light responds.
The remaining control channels come after this first DMX channel (DMX starting address).
The effect light requires 4 or 12 DMX channels depending on DMX operating mode.
Setting the DMX operating mode (channel number)
• Press MENU (3) repeatedly until CHMd appears.
• Push the button ENTER (6) and select the desired DMX operating mode with the buttons UP (5) and
DOWN (4).
4CH = 4-channel DMX operation
12CH = 12-channel DMX operation
• Press the ENTER button (6) to confirm your input.
Setting the DMX starting address
• Push the button MENU (3) repeatedly until Axxx (xxx = set DMX start address) appears.
• Push the button ENTER (6) and select the desired DMX start address with the buttons UP (5) and DOWN
(4).
• Press the ENTER button (6) to confirm your input.
32