Troubleshooting; Disposal - Renkforce S1 Moving Head à DEL Notice D'emploi

14. Troubleshooting

By purchasing the LED moving head, you have acquired a product designed to the state of the art and
operationally reliable. Nevertheless, problems or errors may occur. Therefore, we would like to describe
how to eliminate possible errors here:
Always observe the safety information!
No function after the device has been connected to the power supply:
• The mains plug is not plugged into the socket correctly.
• The mains cable is not correctly connected to the device mains connection POWER IN.
• The mains socket is not supplied with current.
There is no reaction to DMX commands:
• The blackout mode is activated at the DMX controller.
• The DMX address is set wrongly.
• The connection between the DMX controller and the light effect is interrupted.
• The DMX line is too long or subject to interference. Use a special DMX high frequency line. Try placing
the DMX line away from the interference source.
• The polarity of the DMX connections to the DMX controller and light effects are different.
• If possible, try another DMX controller.
The music control does not work:
• Music control is not activated.
• Music playback volume is too low. Try setting a higher volume or increasing microphone sensitivity with
the controller below the microphone MIC (2).
• Test the function of the installed microphone by tapping a finger on the housing. The sound to light con-
trol should react to these impulses.

15. Disposal

Electronic devices are recyclable waste and must not be disposed of in the household waste!
Dispose of the product according to the applicable statutory provisions at the end of its service
life.
40