Safety Information - Renkforce 1086303 Notice D'emploi

4. Safety Information

The warranty/guarantee will expire if damage is incurred resulting from non-compliance with
these operating instructions. We do not assume liability for any consequential damage.
Nor do we assume any liability for damage to property or personal injury caused by improper
use or failure to observe the safety instructions. In such cases the war-ranty/guarantee is vo-
ided.
Dear Customer: The following safety information is intended not only for the protection of the
device but also for the protection of your health. Please read the following items carefully:
• For safety reasons, any unauthorized conversions and/or modifications to the product are not
permitted.
• This device is a safety class 1 product. The only permissible voltage source is a properly groun-
ded mains socket (100-240 V/50/60 Hz) of the public mains.
• Anyone operating, installing, setting up, commissioning or servicing this effect beamer must be
trained and qualified properly and observe these operating instructions.
• Outdoors, use of a suitable mains socket is mandatory. It must be water-protected. This mains
socket must be secured via a fault-current circuit breaker (FI switch) with a tripping current of
<= 30 mA.
• The mains socket to which the product is connected must be easily accessible.
• Any extension lines used outdoors must be suitable for use outdoors as well. Always observe
that the plug must never be in or under water, e.g. in puddles or areas where water may col-
lect due to precipitation or flooding!
• The product is set up according to IP65; it may be installed and operated indoors or outdoors.
Never install the product at or in vehicles, however.
• The product must never be operated in or under water; it would be destroyed by this. More-
over, there is the risk of a fatal electric shock!
• The product must not be installed and operated in areas that are in danger of flooding. This also
applies to areas (e.g. troughs) where water may collect.
• Do not use the product inside of rooms or in bad ambient conditions where flammable gases,
vapours or explosive dust may be or are present! There is a danger of explosion!
• LED radiation may be dangerous if the LED beam or a reflection enters the unprotected eye.
Therefore, familiarise yourself with the statutory regulations and measures of precaution for
the operation of this kind of LED device before using the device.
• Never look straight into the light source during operation. The bright light flashes may tempo-
rarily impair your eyesight. Apart from this, epileptic fits may be triggered under certain cir-
cumstances in persons sensitive to such lights. This particularly applies to epileptics.
• Never touch the mains plug with wet or damp hands. There is a risk of potentially fatal electric
shock!
• Do not touch the mains cable if it is damaged. First, power down the respective mains socket
(e.g. via the respective FI switch and circuit breaker) and then carefully pull the mains plug
from the mains socket. In this case, take the device to a specialist workshop for repair. Never
use the product if the mains cable is damaged.
24