Connecting To A Computer - R&S ETC Guide Rapide

R&S ETC
3.4

Connecting to a Computer

The powerful R&S ETC View software is available for tasks such as documenting
measurement results and creating limit lines and channel tables. The software is
supplied with the R&S ETC, but runs on a computer. To use the R&S ETC View
software, you need to install the R&S ETC View software on your computer (see
software manual) and establish a connection between the R&S ETC and your computer.
For details see chapter 6.1.
If no connection can be established between the R&S ETC View software and
the R&S ETC following successful configuration, check the firewall settings on
your computer.
Getting Started 2116.7884.02 - 04.00
Connecting the Instrument
27