Getting Started; Inserting Batteries In The Remote Control; Connecting The Loudspeakers; Mains Connection - Medion LIFE P64122 Notice D'utilisation

7. Getting started

7.1. Inserting batteries in the remote control

 Open the battery compartment cover as shown on the back of the remote con-
trol.
 Insert the supplied CR 2025, 3 V battery in the remote control.

7.2. Connecting the loudspeakers

 Ensure that your device is not connected to the mains power supply.
 Plug the speaker cables into the correct, corresponding sockets on the rear of
the Micro Audio System. R (right) for the right loudspeaker, L (left) for the left
loudspeaker.

7.3. Mains connection

 Once you have made all the connections, connect the plug to an easily accessi-
ble 100–240 V ~ 50/60 Hz. mains socket.

8. Basic functions

8.1. Switching on the device/standby

 To switch on the device, press the STANDBY button on the device or on the re-
mote control. Symbols appear on the display.
 To switch the device back into standby mode, press the STANDBY button on
the device or on the remote control.
The device is now in standby mode again and the time will appear on the display.
The display lighting dims after a few seconds.

8.2. Setting the time

 Switch the device to standby mode.
 Press and hold the CLOCK/TIMER button on the remote control.
 Press  or  to set 12-hour or 24-hour format.
 Press the CLOCK/TIMER button to confirm the setting.
 The hour display flashes. Press the  or  buttons to set the hour.
 Press the CLOCK/TIMER button to confirm the setting.
The minute display flashes. Press the  or  buttons to set the minutes.
 Press the CLOCK/TIMER button to confirm the setting.
The time is now set. You can display the time for several seconds at any time by
briefly pressing the CLOCK/TIMER button.
42