Getting Started; Connect The Speakers To The Subwoofer; Connect To An Audio Signal; Connecting To A Power Supply - Medion ERAZER X89015 Mode D'emploi

6. Getting started

For information on connecting the sound system, see the following sections and
the illustration in "5.1. Subwoofer/connections" on page 63.

6.1. Connect the speakers to the subwoofer

 Connect the cinch plug of the right speaker to the AUDIO OUT R connection
on the subwoofer.
 Connect the cinch plug of the left speaker to the AUDIO OUT L connection on
the subwoofer.

6.2. Connect to an audio signal

 Plug the 3.5 mm jack plug of the supplied audio cable into the corresponding
output on your audio output device.
 Connect the red cinch plug of the supplied audio cable to the AUDIO IN R
connection on the subwoofer.
 Connect the white cinch plug of the supplied audio cable to the AUDIO IN L
connection on the subwoofer.

6.3. Connecting to a power supply

 Plug the mains plug of the subwoofer into an easily accessible mains socket.

7. Operation

7.1. Switching on/off
 Make sure that the volume control [VOL] is set to its lowest setting. To do this,
turn the volume control [VOL] to the left.
 Switch on your audio source and play a suitable track.
 Switch on your sound system using the on/off switch at the back of the
subwoofer. The subwoofer lights up once the sound system is switched on.
 Adjust the volume to the desired level (see following section).
 To switch off the sound system, use the on/off switch at the back of the
subwoofer.

7.2. Controlling the volume

 In order to adjust the volume, turn the volume control [VOL] on the right side of
the subwoofer:
− to the left: quieter
− to the right: louder

7.3. Adjusting the sound

 You can use the two sound controls [TRE] (treble) and [BASS] (bass) on the
64 of 80