B Icycle Chain And Sprocket, Belt Drive - Flyer MOUNTAIN Série Notice Originale

Rohloff
To access the instructions for the Rohloff E-14
hub gears, visit https://www.rohloff.de/en/service
or scan the following QR code:
For instructions on how to configure the Rohloff
E-14 hub gears in the display D1, see section
5.5.22 "Rohloff menu" in this guide.
Enviolo
To access the instructions for the Enviolo TR
AutomatiQ integrated hub gears, visit https://sup-
port .enviolo .com or scan the following QR code:
For instructions on how to configure the Enviolo
TR AutomatiQ integrated hub gears in the display
D1, see section 5 .5 .17 "Enviolo automatiQ integ-
rated" in this guide .
Despite a perfectly set up derailleur gear
system, a bike chain crossing at an an-
gle can lead to noises during riding .
These noises are normal and do not
cause any damage to the gear compo-
nents .
Do not pedal backwards while changing
gears, as this may damage the gear sys-
tem .
Using faulty, incorrectly set-up or worn
gear components is dangerous and can
lead to falls . If you are concerned, have
components checked and readjusted as
required by a FLYER specialist retailer .
Electronic gears
You may find electronic gears in particu-
lar unfamiliar to operate . Therefore, you
may want to ask your FLYER specialist
retailer for more information and about
this .
When you use the multishift function,
your electronic shifting system shifts very
rapidly to low gears. This significantly re-
duces the pedalling resistance, which
can cause you to lose your balance and
fall . You should take particular care when
shifting down gears . While riding, make
sure that you do not accidentally hold
down the "–" button/rocker switch on the
operating element/button . Do not rest
your fingers on the buttons/rocker swit-
ches while riding . Sudden and accidental
shifting down ("–" button/rocker switch) to
a low gear can cause you to lose control
of the bike .
16. B icycle chain and
sprocket, belt
drive
Bicycle chain maintenance
Bicycle chains are subject to wear depending on
how they are used . The degree of wear varies
considerably . Have the chain of your FLYER reg-
ularly checked by your FLYER specialist retailer .
• Hub gears: approx. 3000 km
• Derailleur gears: approx. 1500 – 2000 km
Chain OK
Chain worn
A worn bike chain can break and cause
very serious falls . Worn bicycle chains
must therefore immediately be changed
by your FLYER specialist retailer .
Regularly care for your bicycle chain by cleaning
and greasing it . These measures reduce prema-
ture wear .
67
EN