Flyer MOUNTAIN Série Notice Originale page 295

Category Code Displayed text
12
2E
0E ECU Maintenance
2F
30
0F 13 Kickstand unfolded
10 14 Not unfolded
11 58 enviolo Communication Error
12 59 enviolo initialisation required
18
33 Remote Error
19
34 1A USB error
35 1B RTC battery empty
36 1C Light Sensor Error
Bluetooth Communication
37 42
Error
43
44
38 Display Software
45
46
47
48
39 49 Display Identification
4A
4B
4C
4D
3A 4E Display Com . Error
4F
50
51
3B 52 Display int . Sensor Error
53
3C 54 Display config. Error
3D 55 Display Overheat
Remedy
Your FLYER e-bike is connected to the mainte-
nance software .
The side stand is unfolded (motor assistance
not possible) . If this is not the case, ask your
FLYER specialist retailer to inspect the sensor in
the side stand .
The folding mechanism is open (motor assis-
tance not possible) . If this is not the case, ask
your FLYER specialist retailer to inspect the
sensor in the side stand .
Check the connections to the enviolo speed
gear . Remove the battery and put it back in
before restarting the system .
Initialise the enviolo speed gear . Settings ->
Calibration -> Calibrate enviolo
Check all connections to the remote .
USB communication error . Remove the device
from the USB port and restart the system .
Check whether the time has been correctly
configured and restart the system. If the error
persists, contact your FLYER specialist retailer .
Clean the display and restart the system . If the
problem persists, contact your FLYER specialist
retailer .
Restart the system . If the problem persists,
contact your FLYER specialist retailer .
Restart the system . If the problem persists,
contact your FLYER specialist retailer .
Verify that the originally supplied components
are connected and restart the system .
Check all connections . Remove the battery and
put it back in before restarting the system .
Restart the system . If the problem persists,
contact your FLYER specialist retailer .
Restart the system . If the problem persists,
contact your FLYER specialist retailer .
Your FLYER e-bike is outside the permitted tem-
perature range . Restart the system . If the problem
persists, contact your FLYER specialist retailer .
44