Flyer MOUNTAIN Série Notice Originale page 312

Then turn the handlebars back to the riding posi-
tion (2) . The bolt must be re-latched (3) .
90°
Completely close the quick-release lever (4) .
4
The Speedlifter quick-release lever must
be completely closed during the ride,
just like any other quick-release fasten-
er . It must also be ensured that the un-
locking bolt is latched in the front hole .
Never adjust the handlebars while rid-
ing .
Read the instructions of the component
manufacturer and for more information
visit: www .speedlifter .com .
1
2
3
Adjusting the stem
For all stems, please read the instruc-
tions supplied by the manufacturer . Only
allow FLYER specialists to work on the
handlebars and stem .
The following stem types are installed on
FLYERS:
A-head stem
Adjustable stem
Adjustable stem
The incline of the stem can be adjusted to your re-
quirements . Depending on the model, the lateral
or internal fastening screw must be loosened and
tightened again after adjustment with the correct
fastening torque .
Changing the position of the stem also
changes the position of the handlebars .
You should always be able to safely
reach and use grips and controls . Han-
dles with a pronounced wing shape may
need to be repositioned .
Make sure that all cables and leads have
a sufficient length to allow for all possible
steering movements when changing the
handlebar and stem position .
61
Fastening screw
EN