Publicité
Les langues disponibles
Les langues disponibles
If configuration of the battery is distributed, this section will be disabled, but it will be present in
the controls of the individual Power Units.
5.4.5 User interface parameters setting RS485, RS232
Inside the COMMUNICATION menu, the parameters can be set relating to communication via
support RS485, RS232.
The section allows setting: the address, the communication mode and the data transmission
speed of the three serial ports available.
5.4.6 Setting network parameters on the touchscreen display
Using the CONFIGURATION, you can configure the parameters relating to the LAN network
and the synchronisation servers of the system time.
All the parameters settable in this section relate to the communication port (LAN) available on
the display.
Figure 31 – SETTINGS section – CONFIGURATION – touchscreen network parameters (System)
5.4.6.1 LAN parameters setting
The configurable parameters are:
➢ IP address
➢ Network mask
➢ Network gateway
➢ Primary DNS server
➢ Secondary DNS server
➢ Enabling/Disabling DHCP
KEOR XPE UPS user manual
Manuel de l'utilisateur de l'ASI KEOR XPE
Utilizzo dell'UPS KEOR XPE
OMAF9213 REV. A
45
Publicité
Chapitres
