Pipetting - StarLab ErgoOne 2,5 Mode D'emploi

2.3 Pipetting

Use the pipette only with tip attached!
Liquid aspiration
Set the required volume (see 2.2 Setting the volume) and attach the
appropriate size pipette tip(s) to the tip holder(s)
• Press the volume control button
• Hold the pipette upright and immerse approx. 3mm of the pipette
tip into the liquid.
• Allow the volume control button
starting position.
• Hold the pipette tip in the liquid for a further 2 seconds to avoid
sucking in air.
• Remove the pipette tip from the liquid.
Dispensing fluids
• Place the pipette tip against the inner wall of the tube or vessel, at
an angle of 30 – 45°.
• Press the volume control button
reaches the first stop position.
• Wait one second and press the volume control button
the second stop position to empty the pipette tip fully (blow out).
• Keeping the volume control button
the pipette tip up the inner wall of the tube to remove any residual
liquid.
• Allow the volume control button
starting position.
• Press the tip ejector button
until the first stop position.
1
to return slowly back to the
1
slowly and evenly until it
1
pressed down, lightly drag
1
to return slowly back to the
1
to eject the pipette tip.
2
ErgoOne ErgoOne User Manual User Manual
® ®
:
7
down to
1
7 7