Transportation And Storage - Dri-Eaz DriTec 4000i Manuel Du Propriétaire

TRANSPORTATION AND STORAGE

NOTICE: Handle the unit carefully. Rough treatment can damage this equipment and may create a hazardous condition
or void warranty.
• Do not expose the control panel to moisture, snow or rain.
• Store and transport securely to avoid any damaging impact to internal parts.
• Secure during transport to prevent sliding and possible injury to vehicle occupants.
MAINTENANCE
WARNING! ELECTRIC SHOCK HAZARD. Unplug unit
before cleaning or servicing.
WARNING: Risk of dust and contaminants exposure.
Use of respirator mask and gloves is recommended.
If unit has been exposed to potentially dangerous
contaminants, clean thoroughly and disinfect before
reuse.
As Needed (Exterior items)
Air Filter. Inspect and vacuum as necessary. Replace
the HAF filter whenever it has been vacuumed clean
and reused three times. See "About 3M High Air Filters"
for more information.
To maintain appearance, wipe interior and exterior sur-
faces with a damp cloth.
Inspect reactivation air outlet ducting for cracks, splits or
breaks. Replace as needed with suitable heat-resistant
ducting.
As Needed (Interior items) See Fig. D.
NOTICE: Electric shock hazard. Unplug unit before re-
moving side panels.
NOTICE: The unit is fitted with sensitive electronic sen-
sors. Protect the sensors and their lead wires from dam-
age and do not expose them to water or cleaning solu-
tion.
The following tools and supplies are needed to complete
the maintenance procedures described in this manual:
• 3 mm Allen wrench and/or bit and cordless drill
• Clean cloths
• Vacuum cleaner with soft brush tool and/or a high
pressure air nozzle
• Phillips screwdriver
Remove side panel. Remove the screws from the react
out / air inlet panel. IMPORTANT: The inlet temp/RH
sensor cable is attached to the interior of the panel
and must be detached before setting the panel aside.
To remove the cable, first unclip the plug and then slide
the cable down and out of the cable tie. Once the cable is
free of the panel, set the panel aside.
Inspect and clean blower
Check that the impeller rotates freely. Vacuum or wipe
clean all surfaces.
Inspect and clean desiccant rotor
Ensure that rotor is clear of dust and debris.
Vacuum or use pressurized air to remove dust from rotor.
Fig. D: Interior views
IMPORTANT! Temp/RH
Sensor cable is attached
to inside of panel! Unclip
and slide out of cable tie
before setting panel
aside.
Detach sensor cable
before setting side pan-
el aside. Be sure to
reinstall cable when
replacing panel.
React out/air in panel.
Remove this panel
only for routine inte-
rior inspection and
cleaning.
Storage
compartment.
Power cord
sockets lo-
cated inside.
Blower
Desiccant
rotor
React air
outlet