Transportation And Storage - Dri-Eaz LGR 7000XLi Guide D'utilisation

AT THE END OF THE JOB
To reduce the possibility of drips when moving the
unit, follow these additional steps to ensure that all
water is removed from the unit.
NOTICE: To ensure all water is removed from the
dehumidifier, the unit will complete the defrost cycle
even if the unit is turned off. If the unit is unplugged
during the defrost cycle, excessive water may
accumulate in the unit and may drip out when you move
the unit. If the defrost cycle is interrupted in this way,
note that the unit will display the message POWER
FAILURE the next time it is powered up. To clear the
message, press the MENU SELECTION key.
NOTICE: To ensure the condensate tank empties
completely while purging, make sure the unit is placed
upright on a horizontal surface.
1. Do not turn unit off or move it until it has returned
to normal operating mode. To confirm unit status,
review the control panel. The control panel will
display one of the following messages:
Defrost in progress:
---
DEFROST XX
Display mode when unit is in defrost mode. XX indicates
the seconds remaining on the defrost cycle.
Shutdown sequence
WAIT FOR
DEFROST XX
Display mode when unit in defrost and unit is powered
down (shut off by user). Unit will complete the defrost
cycle to remove any built-up ice then purge the pump.
XX indicates the seconds remaining on the defrost cycle.
Drying sequence
WAIT FOR
UNIT DRYING XXX
Display mode when unit not in defrost and unit is
powered down (shut off by user). Unit will complete the 5
minute drying cycle then purge the pump. XX indicates
the seconds remaining on the drying cycle.
Normal display:
UNIT ON 00 HRS
INLET XXX°F / XX%
The unit has completed a defrost and drying cycle and
has returned to normal mode. You may now procede to
step 2.
07-01776N F412
2. Gently rock the machine to ensure any water
remaining on interior surfaces falls into the sump
area.
3. Press the PURGE key. When the purge cycle is
complete, turn the unit off.
4. Remove the external drain hose, drain it carefully,
coil it and secure it with one of the straps provided
on the side of the unit.

TRANSPORTATION AND STORAGE

IMPORTANT: Before moving, transporting or
storing, purge unit and stow hose and power cord as
described in the "At the End of the Job" section
above.
NOTICE: Handle the unit carefully. Do not drop, throw or
place the unit where it could fall. Rough treatment can
damage the dehumidifier and may create a hazardous
condition or void the warranty.
• Do not expose the control panel to moisture, snow
or rain.
• Store and transport securely to avoid any damaging
impact to internal parts.
• Secure during transport to prevent sliding and
possible injury to vehicle occupants.
• Do not transport or store the unit on its front, sides or
back. This will help to prevent any remaining moisture
from escaping from the unit or flowing into areas
outside the sump.
Special tip for transporting on stairs:
Before transporting unit on stairs, follow these additional
steps to ensure that all water is removed from the unit:
1. Turn the unit off after a defrost cycle has been
completed. Gently rock the upright machine on its
wheels to ensure any water remaining on interior
surfaces falls into the sump area.
2. Press the PURGE key. When the purge cycle is
complete, turn the unit off.
3. Remove the external drain hose, drain it carefully, and
return it to the pocket provided on the side of the unit.
4. IMPORTANT: Remove power cord from base of
unit, coil it neatly, and place it in the cord storage
pocket. This will prevent the cord from catching on
the stairs and possibly damaging the cord.
5 Legend Brands