Dri-Eaz LGR 7000XLi Guide D'utilisation page 2

FIG. A: FRONT
FIG. C: LOWER BACK PANEL
that could block airflow into and out of the unit. For
more information, contact your Dri-Eaz distributor.
Set up drain hose
This unit automatically pumps out water on a regular
basis. The condensate pump connects to a plastic
drainage hose that is located in the pocket on the side of
the unit. This hose is equipped with a quick-connect
fitting for quick attachment to the provided drain hose.
Unwrap the entire hose and place the unattached end in
a sink, drain, bucket or outdoors – anywhere that water
can drain out safely. If you use a bucket or other
container for water collection, check it regularly to
prevent overflows.
NOTICE: Uncoil and straighten the entire drain hose. Do
not leave any part of the hose coiled on the unit and do
not place the end of the hose higher than 20 ft. (6 m)
above the bottom of the unit. Also check for kinks or
07-01776N F412
FIG. B: BACK
Integrated handle.
Folds for storage.
Humid air inlet
and air filter.
Molded pocket
for cord storage.
Control panel.
Process
(dehumidified) air
outlet. May be
used with standard
12 in. rigid or
layflat ducting.
Back panel. Remove to
access the pump.
Warning label
Serial number.
Drain plug.
2
other obstructions that might restrict the flow of water.
Obstructions may cause a water backup and result in
overflows.
Plug in electrical cord
The dehumidifier should be plugged into a GFCI-
protected 120 volt outlet rated for at least 15 amps.
Remove the cord from its storage pocket and uncoil it.
Always plug the cord firmly into the unit first, and then
plug the other end into a suitable outlet.
Turn the unit on
The control panel has a display and a touchpad with four
keys. Press the ON/OFF to turn the unit on. The unit will
now go through a compressor delay countdown (up to
60 seconds in duration) and a self-diagnostics process,
then switch to normal display mode.
Drain hose pocket.
Drain hose
connection.
Legend Brands