Transportation And Storage; Maintenance Schedule - Dri-Eaz LGR 7000XLi Guide D'utilisation

AT THE END OF THE JOB
To reduce the possibility of drips when moving the
unit, follow these additional steps to ensure that all
water is removed from the unit.
NOTICE: To ensure all water is removed from the
dehumidifier, the unit will complete the defrost cycle
even if the unit is turned off. If the unit is unplugged
during the defrost cycle, excessive water may
accumulate in the unit and may drip out when you move
the unit.
NOTICE: To ensure the condensate tank empties
completely while purging, make sure the unit is placed
upright on a horizontal surface.
1. If the unit is in a defrost cycle, wait until the unit
has returned to normal operating mode before
proceeding. To check, review the control panel. The
control panel will show one of the following:
Defrost in progress:
UNIT ON 00 HRS
DEFROST XX
Display mode when unit is in defrost mode. XX indicates
the seconds remaining on the defrost cycle.
Shutdown sequence
WAIT FOR
DEFROST XX
Display mode when unit in defrost and unit is powered
down (shut off by user). Unit will complete the defrost
cycle to remove any built-up ice then purge the pump.
XX indicates the seconds remaining on the defrost cycle.
Drying sequence
WAIT FOR
UNIT DRYING XX
Display mode when unit not in defrost and unit is
powered down (shut off by user). Unit will complete the 5
minute drying cycle then purge the pump. XX indicates
the seconds remaining on the drying cycle.
Normal display:
UNIT ON 00 HRS
INLET XX° C
Wait until the control shows the normal display before
proceeding.
2. Gently rock the machine to ensure any water
remaining on interior surfaces falls into the sump
area.
3. Press the PURGE key. When the purge cycle is
complete, turn the unit off.
4. Remove the external drain hose, drain it carefully,
coil it and secure it with one of the straps provided
on the side of the unit.
07-01776H F412-115V

TRANSPORTATION AND STORAGE

NOTICE: Handle the unit carefully. Do not drop, throw,
or place the unit where it could fall. Rough treatment can
damage this equipment and may create a hazardous
condition or void warranty.
 Do not expose the control panel to moisture, snow
or rain.
 Store and transport securely to avoid any damaging
impact to internal parts.
 Secure during transport to prevent sliding and
possible injury to vehicle occupants.
Important
Do not store or transport the unit in a horizontal position
(front, sides, or back). This will help to prevent
condensate escaping from the unit unit or flowing into
areas outside the condensate management system.
Special tip for transporting on stairs:
Before transporting unit on stairs, follow these additional
steps to ensure that all water is removed from the unit:
1. Turn the unit off after a defrost cycle has been
completed. Gently rock the upright machine on its
wheels to ensure any water remaining on interior
surfaces falls into the sump area.
2. Press the PURGE key. When the purge cycle is
complete, turn the unit off.
3. Remove the external drain hose, drain it carefully, and
return it to the pocket provided on the side of the unit.
4. IMPORTANT: Remove power cord from base of
unit, coil it neatly, and place it in the cord storage
pocket. This will prevent the cord from catching on
the stairs and possibly damaging the cord.

MAINTENANCE SCHEDULE

WARNING! ELECTRIC SHOCK HAZARD. Unplug the
dehumidifier before performing any maintenance.
WARNING: Risk of dust and contaminants exposure.
Use of respirator mask and gloves is recommended. If
unit has been exposed to potentially dangerous
contaminants, clean thoroughly and sanitize before
reuse.
NOTICE: The unit is fitted with sensitive electronic
sensors. Protect the sensors and their lead wires from
damage and do not expose them to water or cleaning
solution.
The following tools and supplies are needed to
complete the maintenance procedures described in
this manual:
Philips screwdriver
Flat blade screwdriver
Needle-nose pliers
∕
9 in. wrench
16
∕
3
in. nutdriver or socket
8
∕
5
in. socket (to remove pump)
16
6 in. socket extension
Ratchet wrench
6 Dri-Eaz Products, Inc.