Dri-Eaz DriTec 4000i Manuel Du Propriétaire page 8

ER9 BUTTON STUCK
ALL BUTTONS
ER10 WIRELESS
CONNECTION ON BD
ABOUT 3M™ HIGH AIR FLOW FILTERS
HAF filters from 3M provide superior particle retention, resist microbial growth on filter surfaces and allow for maximum
airflow throughout the filter loading cycle. Follow these guidelines to ensure maximum protection for equipment, techni-
cians and the job site:
Replace the HAF filter whenever it has been vacuumed clean and reused three times. HAF filters lose their effectiveness after
three uses.
Replace the HAF filter whenever it has been used on a mold remediation job or otherwise exposed to potentially dangerous
contaminants. Continued use of a contaminated filter risks the spread of contamination.
Do not wash or apply any liquids to the HAF filter. Exposure to liquids will reduce the effectiveness of the electrostatic material.
Do not operate without the HAF filter in place. Do not operate the unit with any other filter type. Incorrect filtration will reduce
unit efficiency and can cause damage to the unit.
Key is stuck - or has been held down much too long. Contact Dri-Eaz service depart-
ment for service/warranty support.
Wireless board has failed, either is missing, shorted or fallen off the control panel. Re-
install wireless board to clear error. Contact Dri-Eaz service department for ser-
vice/warranty support.