Connecting The Electrical Power To Magicspeed - Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service

Connecting the electrical power to MagicSpeed

7.3 Installing the clutch switch
NOTE
I
Check whether your vehicle features a clutch switch. If it does, you
do not have to install the clutch switch supplied.
Install the clutch switch as follows (fig. 8, page 7):
Fasten the magnet (fig. 8 1, page 7) to the clutch pedal using double-
sided adhesive tape or cable binders.
Fasten the clutch switch (fig. 8 2, page 7) in the footwell using the
screws supplied or double-sided adhesive tape.
Connect the 2-pole clutch switch compact plug (fig. 8 2, page 7) with the
2-pole compact plug on the cruise control cable set.
NOTE
I
On vehicles with manual transmission, you can use the clutch
switch to prevent engine overspeed. The cruise control switches off
automatically when you press down the clutch.
8 Connecting the electrical power to
MagicSpeed
8.1 General notes on laying cables
As far as possible, use original ducts for laying the cables, or other suitable
options, such as panelling edges, ventilation grilles or dummy plugs. If no
openings are available, you must drill holes for the cables. Check beforehand
that there is sufficient space on the other side for the drill head to emerge.
Cables and connections that are not properly installed will cause malfunc-
tions or damage to components. Correct installation of cables and connec-
tions ensures lasting and trouble-free operation of the retrofitted
components.
74
MagicSpeed MS880
EN