Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 75

MagicSpeed MS880
Therefore, please observe the following instructions:
To prevent damage to the cables when laying them, ensure that they are
far enough away from hot or moving vehicle components (exhaust pipes,
drive shafts, light systems, fans, heater etc.).
Wrap insulating tape around every connection on the cable (even inside
the vehicle).
When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3,
page 4).
Protect every hole you drill against water penetration, e.g. by using a ca-
ble with a sealant and by spraying the cable and the the cable sleeve with
sealant.
8.2 Laying and connecting the cable set
Once you have decided where to install the electronic module, you can lay
the cruise control cable set and connect it.
You will find a summary of the wiring in fig. 7, page 6.
No. Component
1 Electronic module
2 Control element
3 Ignition coil
4 Engine speed signal
5 Brake light switch
6 Original clutch switch
7 Clutch switch
8 Ignition
9 Travel speed signal
10 Vehicle-specific cable set (not included)
EN
Connecting the electrical power to MagicSpeed
75