Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 89

MagicSpeed MS880
Step 2 (accelerator pedal test)
Press the accelerator pedal slowly as far as it will go and let it return the
same way slowly as far as the neutral position.
While this happens,you will hear acoustic signals which signify the various
positions:
– Neutral position (idle):
– 50% position:
– 100% position:
NOTE
I
If a low-pitched signal does not sound or you hear a high-
pitched signal during the pedal test, this step has failed and
programming must be repeated from step 1.
Some accelerator pedals do not provide sufficient electric sig-
nals when fully pressed down. In this case, only press the pedal
approx. three-quarters of the way down in step 2, as otherwise
the test will not be successful.
Step 3 (quit synchronisation)
Switch the ignition off.
Normally, your cruise control should be ideally preset for your vehicle.
Refer to the figure on page 90 for a summary of the CAN bus connection and
pedal test.
EN
Synchronising with a CAN-bus connection
...
...
...
89