Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 90

Synchronising with a CAN-bus connection
Step 1:
synchronisation
CAN bus search
unsuccessful
Step 2:
pedal test begins
Pedal test
unsuccessful
MT: manual transmission
AT: automatic transmission
90
Press and hold down
MT: Press the brake and
clutch pedals and hold down
AT: press and hold down
the brake pedal + neutral position
1 long beep
Electronic module LED flashes:
CAN bus search in progress
Electronic module LED is lit up constantly:
CAN bus search successful
MT: release brake and clutch pedal
AT: release brake pedal + park position
Sound sequence:
Neutral position of gas pedal detected
Continuous
Press accelerator
high/low-pitched
beeps
Sound sequence:
50% position detected
Press down accelerator
all the way (100%)
Sound sequence:
100% position detected
MagicSpeed MS880
the SW1 button
Ignition ON
2 beeps
Release the
Analog
SW1 button
CAN Bus
Press the
SET button
3 beeps
...
pedal 50%
...
...
Pedal test
successful
Ignition OFF
Press the
RES button
4 beeps
System
is reset
System for
analog connection
configured
Ignition OFF
Continue with
setup mode
EN