Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 67

MagicSpeed MS880
The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
Secure the parts of the parking aid installed in the vehicle in such a way
that they cannot become loose under any circumstances (sudden brak-
ing, accidents) and cause injuries to the occupants of the vehicle.
Secure any parts of the system covered by the bodywork in such a man-
ner that they cannot be come loose or damage other parts and cables or
impair vehicle functions (steering, pedals, etc).
To prevent damage when drilling, make sure there is sufficient space on
the other side for the drill head to come out.
Deburr all drill holes and treat them with a rust-protection agent.
Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only
be performed by qualified specialists.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
or a voltmeter.
Test lamps with an illuminant take up voltages which are too high and
which can damage the vehicle's electronic system.
When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
EN
Safety and installation instructions
67