Connection Options; Safety Features - Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service

Technical description
MagicSpeed is comprised of an electronic module and a cable set. The elec-
tronic module is connected to a control element (accessory, e. g. a lever or
infrared steering wheel remote control) with which you can make the required
settings. The control element is fitted in the dashboard area.
The system is equipped with various safety features for your protection.
6.2

Connection options

MagicSpeed MS880 can process either a digital speed signal from the CAN
bus (CAN bus connection) or an analogue speed signal (analogue connec-
tion). A CAN bus connection is not possible in all vehicles with a CAN bus.
NOTE for vehicles with CAN bus
I
You can find out whether a CAN bus connection is possible for
your vehicle from the vehicle-specific product overview on our
homepage, or by calling to enquire (see rear page of the manual
for contact data).
If your vehicle features a CAN bus, but a CAN bus connection
is not possible according to the vehicle list, MagicSpeed MS880
must be connected using a analogue connector. This will re-
quire the speed signal to be received in analogue form.
If the speed signal is only available on the CAN bus in digital
form, you will require the CAN bus interface MagicSpeed
CBI 150 for the installation of MagicSpeed MS880. This con-
verts the digital speed signal from the CAN bus into an analogue
one.
A CAN bus interface is not required for the CAN bus connection.
6.3

Safety features

NOTICE!
A
If your vehicle has a steering wheel lock, make sure that it is not
activated when the key is in the ignition or a gear is selected.
The cruise control is equipped with numerous safety features to switch it off
if any of the following situations arise:
The brake is applied hard
Pressing the accelerator and brake pedal at the same time (savior func-
tion)
70
MagicSpeed MS880
EN