Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 97

MagicSpeed MS880
You can now use MagicSpeed MS880.
NOTE
I
If, during operation, you notice that the vehicle reacts too slowly or
too suddenly, or the speed is not being regulated correctly, you
must set the control sensitivity manually (see chapter "Setting the
control sensitivity manually (GAIN mode)" on page 98).
12.6 Setting the sensitivity (INIT mode)
In INIT mode you can set the sensitivity of speed reaction. If the speed reg-
ulator reacts to the speed too slowly you must increase the INIT value. If it
reacts too suddenly to the speed, you must decrease the INIT value.
Start setup mode (chapter "Starting setup mode" on page 91).
To set the sensitivity, apply the brake and hold it down.
With the brake applied, press the RES button three times.
You will hear a low-pitched signal each time you press the button.
Release the brake.
You will hear three high-pitched signals.
NOTE
I
If you do not hear three signals, repeat the procedure.
With the speed controller activated, drive at any speed above the activa-
tion speed (40 km/h).
Press the SET button until the speed regulator takes on the speed you are
driving at.
Switch off the speed regulator by applying the brake.
Press the SET button.
You will hear a high-pitched signal each time you press the button.
The speed regulator gently takes on the speed.
NOTE
I
The normal functions of the SET and RES buttons are disabled in
this mode, which means you can use the buttons to make the set-
tings.
EN
Synchronising with an analogue connection
97