Dometic Waeco MagicSpeed MS880 Instructions De Montage Et De Service page 95

MagicSpeed MS880
Press and hold down the SET button.
Start the engine.
When the engine is running, let go of the SET button.
Now switch on the speed controller using the ON/OFF button on the
control element.
The LED in the control element lights up.
NOTICE!
A
Do not let the engine overrun.
To increase the engine speed press and hold down the SET button.
The engine speed slowly increases.
To reduce the engine speed press and hold down the RES button.
The engine speed slowly drops.
To drop the engine speed back down to the idle speed again,
– apply the brake or clutch, or
– press the ON/OFF button on the control element.
To quit diagnosis mode, switch off the ignition.
NOTE
I
For safety reasons, the engine speed can only be increased by
66 % of the maximum value.
Diagnosis mode C
Diagnosis mode C tests the travel speed or engine speed signal.
Press and hold down the SET button.
Start the engine.
When the engine is running, let go of the SET button.
Drive your vehicle at a speed of around 50 km/h.
Now switch on the cruise control using the ON/OFF button on the control
element.
The LED in the electronic module flashes and an audible signal sounds
once per second.
EN
Synchronising with an analogue connection
95