Connecting And Installing Mpc01; Changing The Operating Mode - Dometic ENERGY & LIGHTING MPC01 Instructions De Montage Et De Service

MPC01
7

Connecting and installing MPC01

7.1 Notes on installation
When selecting the installation location for the display and adapter board, observe the following
instructions:
• The device must be installed in a location that is protected from moisture.
• Do not install the device in a dusty environment.
• The device must be installed on a level and sufficiently sturdy surface.
• Ensure the control cable is 6 m long.
• Install the adapter board in a well-protected location, close to the batteries if possible, to ensure
no objects can touch the connection cable and cause it to tear.
7.2

Changing the operating mode

The operating mode is set using the jumper (fig. 3 1, page 4). The jumper is already plugged in
when the device is delivered, and set to the "caravan" operating mode.
➤ To set the "boat" operating mode: Remove the jumper (fig. 3 1, page 4).
7.3 Connecting and installing the display
You can install the MPC01 on the wall or in the wall. For installation on the wall, the control cable
can either be guided through the wall or affixed on the wall.
Installing the display on a wall (fig. 4 A, page 4)
➤ Plug the control cable (1) into the connection on the display.
➤ Guide the control cablethrough the slot in the installation frame.
➤ Place the display in the installation frame.
➤ Affix the installation frame and display insert onto a suitable part of the wall using the four long
screws supplied.
➤ Attach the cover frame so that it latches into place.
Installing the display in a wall (fig. 4 A, page 4)
➤ Prepare a recess in the wall measuring 11 x 9.9 cm and which is 2.5 cm in depth.
➤ Plug the control cable (fig. 1 8, page 3) into the connection on the display.
➤ Affix the display (fig. 1 3, page 3) using the four short screws supplied (fig. 1 12, page 3).
➤ Attach the cover frame (fig. 1 2, page 3) so that it latches into place.
EN
Connecting and installing MPC01
11