Dometic ENERGY & LIGHTING MPC01 Instructions De Montage Et De Service page 21

MPC01
Changing values
➤ Press the selector button so the value can be changed.
➤ Turn the selector button to set the required value.
➤ Press the selector button to save the value.
When values are being changed, an arrow appears (fig. 7 1, page 6).
➤ Turn the selector button to mark the arrow.
➤ Press the selector button to exit setting mode.
➤ Turn the selector button until the message "Press to return" appears and then press the
selector button.
✓ This will return you to the "Main menu".
Changing system settings
➤ Navigate to the "System settings" menu page (page 16), see chapter "Navigating within the
menu" on page 14. Set the values for:
– Date and time
– Alarm
➤ Press the selector button.
➤ Turn the selector button to access the relevant parameter.
➤ Press the selector button and turn it to set the required value.
➤ Confirm the value by pressing the selector button.
Setting time intervals
➤ Navigate to the "Stand-by settings" menu page (page 16), see chapter "Navigating within the
menu" on page 14.
Set the interval after which the main menu should appear automatically (fig. 8 1, page 6) or after
which the MPC01 should switch to stand-by mode (fig. 8 2, page 6). You can choose between
the following intervals: 30 sec, 1 min, 2 min, 10 min, "---" (continuous).
➤ Set the required value, see chapter "Changing values" on page 21.
EN
Operating the MPC01
21