Edge Control; Important; Edge Selection And Assembly - Virutex EB140 Mode D'emploi

C
D
E
(Figure 22)
B
A

5.2 EDGE CONTROL

IMPORTANT

The edge should not protrude from the board more than 1.5
mm. If the distance is greater than this, the final finish will
not be the most appropriate.
Close the air safety valve as explained in sec-
tion 5.1 before beginning to adjust the edge.

5.2.1 Edge selection and assembly

(Figure 22)
Lift rear cover A, loosen crank handle B and open feeder C.
Place edge reel D on the loader, as shown in the figure and
thread the edge through window E.
(Continued on page 22)
EB140 / Operating instructions - 85