Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Inogen One G2 Manuel D'utilisation

Guidance and Manufacturer's Declaration - Electromagnetic Immunity

(continued):
Immunity Test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
42
IEC 60601
Test Level
± 6 kV contact ± 6 kV contact
± 8 kV air ± 8 kV air
± 2 kV for power ± 2 kV for power
supply lines supply lines
± 1 kV for input/ ± 1 kV for input/
output lines output lines
± 1 kV line(s) to ± 1 kV line(s) to
line(s) line(s)
± 2 kV line(s) to ± 2 kV line(s) to
earth earth
Compliance
Level Environment - Guidance
Field strengths from fixed RF
transmitters, as determined
by an electromagnetic site
survey
compliance level in each
frequency range
Interference may occur in the
vicinity of equipment marked
with the following symbol:
Floors should be wood, concrete
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should
be at least 30 %.
Mains power quality should be
that of a typical commercial or
hospital environment.
Mains power quality should be
that of a typical commercial or
hospital environment.
Electromagnetic
, should be less than the
a
.
b