Battery Care And Maintenance - Inogen One G2 Manuel D'utilisation

When battery life is low, do one of the following:
• Plug the Inogen One® G2 into an AC or DC power source using the Universal Power Supply.
• Replace the battery with a charged battery after turning off the Inogen One® G2
(by pressing the ON/OFF button).
• If the battery is drained, charge the battery or remove it from the concentrator.
If the Inogen One® G2 is being powered by the Universal Power Supply, batteries will charge
during operation. Leaving your Inogen One® G2 plugged in past the full charge time will not
harm the concentrator or the battery.
WARNING It is the responsibility of the patient to periodically check the battery and
replace as necessary. Inogen assumes no liability for persons choosing not to
! C
adhere to manufacturer recommendations.
Normal Battery Charging
To ensure that your battery is properly charging, inspect that the correct AC and DC power
output plug adapter is being used and that the adapter is properly inserted into the power
outlet. Observe the display or lights that indicate charging status.
NOTE When starting to charge a fully discharged battery, the charging process may
start and stop during the first few minutes.

Battery Care and Maintenance

Your Inogen One® G2 Lithium Ion Battery requires special care to ensure proper performance
and long life. Use only Inogen One® G2 Batteries with your Inogen One® G2 Concentrator.
Keep Dry
Always keep liquids away from batteries. If batteries become wet, discontinue use
immediately and dispose of battery properly.
Effect of Temperature on Battery Performance
The Inogen One® G2 single battery powers the Inogen One® G2 Concentrator from 2 to 5
hours under most environmental conditions. To extend the run-time of your battery, avoid
running in temperatures less than 41˚F (5˚C) or higher than 95˚F (35˚C) for extended periods
of time.
Operating Instructions Chapter 3
21