Inogen One G2 Manuel D'utilisation page 22

and securely remain in place. The Cigarette Lighter Adapter comes with a slide switch
pre-adjusted to the narrow position. This will fit most automobile cigarette lighter sock-
ets. If the Cigarette Lighter Adapter is loose in the socket, adjust the switch to the "wide"
position.
WARNING Ensure that the automobile power socket is adequately fused for the Inogen
One® G2 power requirements (minimum 15 Amp). If the power socket cannot
C
!
support a 15 Amp load, the fuse may blow or the socket may be damaged.
WARNING The tip of the Cigarette Adapter Plug becomes HOT when in use. Do not touch
C
!
the tip immediately after removal from an auto cigarette lighter socket.
CAUTION Ensure the automobile power socket is clean of cigarette ash and the adapter
plug fits properly, otherwise overheating may occur.
CAUTION Do not use the Universal Power Supply with a cigarette plug splitter or with
an extension cable. This may cause overheating of the DC power input cable.
CAUTION Do not jump start the automobile with the Universal Power Supply connected.
This may lead to voltage spikes which could shut down and/or damage the
Universal Power Supply.
CAUTION When powering the Inogen One® G2 in an automobile ensure the engine is
running. Operating the device without the engine running may drain the car
battery.
CAUTION A change in altitude (for example, from sea level to mountains) may affect total
oxygen available to the patient. Consult your physician before traveling to
higher or lower altitudes to determine if your flow settings should be changed.
Traveling By Air
The FAA allows the Inogen One® G2 onboard all U.S. aircraft, here are a few points to make
air travel easy.
Planning Your Flight
When flying with the Inogen One® G2, you must inform the airline that you will be using
your Inogen One® G2 onboard the aircraft. You must also keep a signed statement from your
physician with you that includes:
18