Height Adjustment - Palazzetti SUNNY FIRE Manuel D'installation Et D'entretien

6.2

HEIGHT ADJUSTMENT

To adjust the nal height of the Ecomonoblocco (cladding
re bed height), just turn the adjustment screws locted
on the base. Adjsut the screws (Fig. 6.3a: A-adjustment
screw, B- re bed height), until the marble cover pro le on
the Ecomonoblocco is at the proper height compared to
the cladding, making sure that the bottom of the replace
is level. For cladding with re bed H 30 cm, remove the
adjustment screws. Where featured, the lever for the
adjustment of combustion air must be about 0.5 cm over
the cladding surface, so that it is easily usable. (Fig. 6.3b).
5 mm
5 mm
- 6.3a -
5 mm
0, 5 cm
B
B
A
A
- 6.3b -
2 m
0,4 m
- 6.4 -