Safety Precuations; Instructions For The Installer; Instructions For The User; Precautions For The Maintenance Engineer - Palazzetti SUNNY FIRE Manuel D'installation Et D'entretien

2 SAFETY PRECUATIONS

2.1

INSTRUCTIONS FOR THE INSTALLER

• Make sure that the place of installation of the replace
meets all local, national and European rules and
regulations.
• Comply with the indications given in this manual.
• Check that the ue and air intake are suitable for the
type of installation opted for and all local, national and
European rules and regulations.
• The electrical connection must not be done using
temporary or non-insulated leads.
• Check that the earthing of the electrical system is ef cient.
• Always use the individual safety devices and the other
protection gear as established by law.
2.2

INSTRUCTIONS FOR THE USER

• Prepare the place of installation of the fireplace in
accordance with the local, national and European rules
and regulations.
• Since the replace is an appliance that heats, its outer
surfaces can get very hot.
• For this reason we advise maximum caution when it is
working, in particular:
A) Do not touch or go near the glass door as you
could get burnt;
B) do not touch the smoke discharge;
C) do not empty the ashes;
D) do not do any type of cleaning;
E) make sure that children are kept away.
• Comply with the indications given in this manual.
• Comply with the instructions and warnings given on
the plates on the replace.
• The plates are accident prevention devices and as
such must be easily and perfectly legible at all times.
Should they be damaged and rendered illegible it is
compulsory to change them, asking the manufacturer
for an original plate.
• Only use fuel that complies with the indications given
in the chapter referring to fuel characteristics.
• Keep strictly to the routine and extraordinary
maintenance programme to the replace and to the
system.
• Do not use the replace without rst having carried out
the daily inspection as speci ed in the "Maintenance"
chapter in this manual.
• Do not use the replace if there is a malfunction, a
suspected breakage or noises.
• Do not throw water on the replace when it is lit or to
put the re out in the hearth.
• Do not lean against the open door during the cleaning
operations.
• Do not use the replace as a support or anchor of
any type.
• Do not clean the replace until the structure and ashes
are completely cold.
• All work must be carried out in maximum safety and
calmly.
• In the event of a chimney re, attempt to extinguish the
re by closing the primary air required for combustion,
and then by smothering the ame. Immediately call
for emergency assistance.
• The safety and lling pipes must be protected against
freezing wherever this may occur.
• Do not use the replace as an incinerator for waste.
Use only recommended fuel.
• If the stove malfunctions due to improper draught of
the ue, clean it contacting quali ed personnel.
The ue must in any case be cleaned at least once a year.
Imperfect draft of the flue may also be caused by
especially severe weather conditions (typically low
pressure). In this case the ue must be well heated. For
this purpose, perform lighting correctly according to the
procedure described below.
2.3 PRECAUTIONS FOR THE MAINTENANCE
ENGINEER
Comply with the indications given in this manual.
• Always use individual safety devices and other
protection means.
• Before undertaking any maintenance, if the replace
has been used, it must be completely cold.
Even if only one of the safety devices is not working, the
replace is to be considered "not working".
• Disconnect from the electrical power supply before
working on electrical or electronic parts or connectors.