Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi CG36DL (L) Mode D'emploi

APPLICATIONS

Trimming, scaling and mowing of weed.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the housing tightly and push the battery latch
to remove the battery (See Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
push

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted
into the receptacle, the pilot lamp will blink in red.
(At 1-second intervals)

ASSEMBLY AND OPERATION

Battery
Pull out
Insert
Latch
Fig. 3
WARNING
Do not use the electrical cord if
damaged.
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts until the line is visible.
Pilot lamp
Before insert
After insert
3. Charging
When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light
in red. (See Table 2)
NOTE
If the pilot lamp flickers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
English
Have it repaired
Battery
Line
Fig. 4
13