Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi CG 18DSDL Instructions De Sécurité Et Mode D'emploi

APPLICATIONS

Trimming, scaling and mowing of weed.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the housing tightly and push the battery latch
to remove the battery (See Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
push

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
WARNING
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.

ASSEMBLY AND OPERATION

Push out
Insert
Battery
Latch
Fig. 3
1. Insert the plug of battery charger into the
receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At
1-second intervals)
WARNING
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4. Make sure it contacts the bottom of the
battery charger.
<UC18YGSL>
English
BSL1830
<UC18YKSL>
Fig. 4
13