Hitachi CG 18DSDL Instructions De Sécurité Et Mode D'emploi page 14

Masquer les pouces Voir aussi pour CG 18DSDL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
3.
Charging
When the battery is inserted into the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE
If the pilot lamp does not light or blink in red, pull
out the plug from the receptacle and check if the
battery is properly mounted.
Before
charging
While
charging
Charging
complete
Pilot lamp
(red)
Overheat
standby
Charging
impossible
Regarding the temperature of the rechargeable
battery.
The temperatures for rechargeable batteries are
as shown in the Table 3, and batteries that have
become hot should be cooled for a while before
being recharged.
Table 3 Recharging ranges of batteries
Rechargeable
Temperatures at which the
batteries
BSL1830
Regarding recharging time
Table 4 shows the recharging time required
according to the type of battery.
Table 4 Recharging time (approx. min.) at 20°C
Battery Voltage (V)
18V
NOTE
The recharging time may vary according to the
ambient temperature.
14
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light
Blinks
for 0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not light
Blinks
for 0.5 seconds. (off for 0.5 seconds)
Lights for 1 second. Does not light
Blinks
for 0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light
Flickers for 0.1 seconds. (off for 0.1 seconds)
battery can be recharged
32°F – 122°F
(0°C – 50°C)
Battery capacity (Ah)
Li-ion BATTERY
3.0 Ah
BSL1830
90 min.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
Table 2
4.
Disconnect battery charger from the receptacle.
CAUTION
Do not pull the plug out of the receptacle by pulling
on the cord.
Make sure to grasp the plug when removing from
receptacle to avoid damaging cord.
5.
Hold the charger firmly and pull out the battery.
Supporting the battery charger with hand, pull out
the battery from the battery charger.
NOTE
After operation, pull out batteries from the charger
first, and then keep the batteries properly.
Regarding electric discharge in case of new
batteries, etc.
As the internal chemical substance of new batteries
and batteries that have not been used for an
extended period is not activated, the electric
discharge might be low when using them the first
and second time. This is a temporary
phenomenon, and normal time required for
recharging will be restored by recharging the
batteries 2 – 3 times.
Battery overheated.
Unable to charge.
(Charging will
commence when
battery cools)
Malfunction in the
battery or the charger

Publicité

Table des Matières
loading

Table des Matières