Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
PRIOR TO OPERATION
CAUTION
Pull out battery before doing any assembly.
1.
Installing the loop handle (Fig. 7)
(1) Remove the finger-tight M6 × 43 bolts (2 pcs.).
(2) Install the loop handle on the main pipe so that it
leans against the housing.
(3) Place the handle fixture at the lower end of the
main pipe and secure it firmly using M6 × 43 bolts
(2 pcs.) and M6 nuts (2 pcs.).
M6 nuts (2 pcs.)
Loop handle
M6 × 43 bolts (2 pcs.)
NOTE
Secure the loop handle in a location that provides
a good grip.
CAUTION
Install the loop handle properly and securely as
instructed in the handling instructions.
If not attached properly or securely, it may come
off and cause injury.
2.
Installing cover (Fig. 8, 9)
WARNING
Be sure to install the cover in its designated
location.
Failure to heed this warning may result in injury
from flying stones.
16
Remaining battery
indicator lamp
Fig. 6
Housing side
Main pipe
Handle fixture
Fig. 7
NOTE
Use the supplied Allen wrench 4mm for
installation.
(1) Use the supplied D5 tapping screw to install the
knife in the cover. (Fig. 8)
Knife
Cover
D5 tapping screw
(2) Align the two holes in the cover bracket and the
cover and insert two M6 × 25 hex. socket button
bolts passed through a M6 spring washer
respectively. (The cover bracket is installed in the
motor case.)
(3) Place the cover holder on the underside of the
cover and use the supplied Allen wrench 4 mm to
alternately tighten the two M6 × 25 hex. socket
button bolts until they are properly tightened.
M6 × 25 hex. socket
button bolts (2 pcs.)
Cover
CAUTION
Take care to avoid cutting yourself on the knife
inside the cover.
Install the cover and knife properly and securely
as instructed in the handling instructions.
If not attached properly or securely, they may
come off and cause injury.
NYLON HEAD
Installation of semi-auto nylon head
1.
Function
Automatically feeds more nylon cutting line when
it is tapped .
Fig. 8
M6 spring
washers (2 pcs.)
Cover bracket
Cover holder
Fig. 9
Publicité
Table des Matières
Dépannage
