Troubleshooting - Hitachi CG 18DSDL Instructions De Sécurité Et Mode D'emploi

Masquer les pouces Voir aussi pour CG 18DSDL:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English

TROUBLESHOOTING

Use the inspections in the table below if the gardening
appliance does not operate normally. If this does not
remedy the problem, consult your dealer or the Hitachi
Authorized Service Center.
Symptom
Charger
The Charge lamp does not
go on.
The Charge lamp does not
go off after 4 hours of
charging.
Gardening
Does not operate.
appliance
24
Possible cause
The power plug is not connected
to an AC outlet.
The battery is not properly
connected to the charger.
The battery or charger electrodes
are soiled.
The battery is extremely hot.
The battery or charger is faulty.
The rechargeable battery is
depleted.
The rechargeable battery has not
been properly installed.
The power has not been turned
on.
The lock lever was not pressed
when the lever was pulled back.
Remedy
Connect the power plug to an AC
outlet.
Insert the battery so that it is
properly seated in the charger.
Use a cotton swab or other tool to
clean the electrodes.
Allow the battery to properly cool
before charging.
Disconnect the power plug and
consult your dealer or the Hitachi
Authorized Service Center.
Charge the rechargeable battery.
Remove the rechargeable battery
from the battery compartment in
the gardening appliance and
check for and remove any foreign
matter. Also check the battery
electrodes for soiling, water or
other foreign matter. Use a cotton
swab for cleaning. Make sure that
the rechargeable battery is
pressed in until it clicks into place.
Press the power button on the
housing to start the gardening
appliance. This gardening
appliance comes with an auto
power off function. The power is
automatically turned off if nobody
pulls the lever during a one
minute period after power on. To
turn the gardening appliance on
again, press the power button a
second time.
Pressing the power button a
second time turns the power off.
To prevent accidents from
incorrect operation, the lock lever
must be pressed while the lever is
pulled back to start the motor.
Hold the handle from above and
press the lock lever while pulling
the handle.

Publicité

Table des Matières
loading

Table des Matières