Hitachi CG 18DSDL Instructions De Sécurité Et Mode D'emploi page 18

English
Tap
Also, you can extend nylon line with hands. This
time the motor must be completely stopped.
Confirm the line extends in 1-3/16" (30 mm) increments
by "tapping" and "releasing" the bottom button while
pulling the line ends of the nylon head. (Fig. 15)
Appropriate length of nylon line
The appropriate length of the line when the gardening
appliance is in use is 3-17/32"– 4-5/16" (90 – 110 mm).
Extend the line to the appropriate length.
Tap/release
4. Nylon line replacement
(1) Prepare 6.56 ft. (2 m) of genuine nylon line in Fig.
10. (Code No.334128)
If the cross section is circular, 0.055 in. (ø1.4 mm)
of line can be used.
(2) Press the opposing tabs, and then remove the
cover from the case. (Fig. 16)
Cover
(3) Remove the reel from the case. (Fig. 17)
If there is nylon line remaining, hook the line in
the groves, and then remove the reel.
18
Nylon head
Fig. 14
Extends in 1-3/16"
(30 mm) increments
Appropriate length
3-17/32"– 4-5/16"
(90 – 110 mm)
Fig. 15
Tab
Press tabs
(2 areas)
Case
Fig. 16
If the nylon line does not extend when there is
enough nylon line remaining, or when replacing
the nylon line (Code No. 334128), wind the nylon
line using the following procedure.
Groove
(4) Hook the nylon line in the grooves of the reel as
shown in Fig. 18 and 19, and then wind the line in
the direction of the arrow so that the nylon line
does not cross.
Reel
Nylon line
Hole of
Groove of
the reel
the reel
Fig. 18
(5) Leave about 3-15/16" – 5-15/16" (100 mm – 150 mm)
nylon cord unwound, hook and secure the line in
the stopper. (Fig. 20)
Secure in the
stopper
NOTE
Do not cross the nylon line when securing the line
in the stopper. (Fig. 21)
Reel
Case
Fig. 17
Nylon
Reel
line
Folded
center of
nylon
cord
Fig. 19
Fig. 20