Power Button; Operation - Hitachi CG36DL (L) Mode D'emploi

Extended length
3-17/32"– 4-5/16" (90 mm – 110 mm)

OPERATION

Trimming grass
WARNING
●
Do not operate the gardening appliance at night
or under bad weather conditions when visibility
is poor.
●
Do not operate the gardening appliance when it
is raining or right after it has been raining.
●
Wear proper footwear to prevent slipping that
could cause you to lose your balance and fall.
●
Do not use the gardening appliance on steep
slopes.
When trimming grass on slopes that are not so
steep, trim by moving towards the ridge.
●
Place the right hand on the handle and the left
hand on the loop handle and hold it firmly.
●
Take care not to move the nylon head too close
to your feet.
●
Do not raise the nylon head above your knee
during cutting.
●
Do not use the gardening appliance where the
nylon head may come into contact with stones,
tree and other obstacles.
●
A nylon head can injure while it continues to spin
after the motor is stopped. When the unit is turned
off , make sure the nylon head has stopped before
the unit is set down.
●
Do not use the gardening appliance within 50ft.
(15 m) of another person. When you work with
someone else, maintain a distance of more than
50ft. (15 m).
1. Insert the battery while observing its polarities.
2. Turn on the gardening appliance. (Fig. 31)
Press the power button on the housing, the power
goes on and the power lamp on the handle lights
red.
Pressing the power button a second time turns the
power off and the red lamp on the handle goes off.
Fig. 30

Power button

Power Lamp
[Auto power off]
When the power is turned on but the lever is not
used for one minute, the gardening appliance is
automatically turned off. To turn the gardening
appliance on again, press the power button a
second time.
WARNING
Never leave the gardening appliance with the
power on. This could result in an accident.
2. Lever Operation and Brake
To start rotation of the cutting blade, with the
power turned on, pull the lever while pressing the
lock lever. (Fig. 32)
When you release the lever, the brake engages in
1-3 seconds, stopping rotation of the cutting blade.
(Fig. 33)
Make sure that the brake operates normally before
using the gardening appliance.
Press the lock lever
English
Switch Panel
Fig. 31
Pull the lever
Fig. 32
The brake
engages when
you release the
lever
Fig. 33
21