Hitachi CG36DL (L) Mode D'emploi page 16

English
M6 nuts (2 pcs.)
Loop handle
M6 × 43 bolts (2 pcs.)
NOTE
Secure the loop handle in a location that provides
a good grip.
CAUTION
Install the loop handle properly and securely as
instructed in the handling instructions.
If not attached properly or securely, it may come
off and cause injury.
2. Extending the main pipe (CG36DAL(L) only)
(1) Release the locking lever to allow the main pipe to
be extended. (Fig. 8)
Main pipe
Loking lever
Holder case
(2) Extend the main pipe as far as it will go, making
sure that you hear it click. (Fig. 9)
NOTE
The motor will not operate unless the main pipe is
fully extended.
When you push the power button, the red power
light will flash rapidly.
(3) After extending the main pipe until it clicks, check
that the hole of the holder case is aligned with the
hole of the main pipe and lock the locking lever to
fix the main pipe securely. (Fig. 9)
16
Housing side
Main pipe
Handle fixture
Fig. 7
Extend
Release
Fig. 8
* Extend the main pipe as
far as it will go
Click
Hole
Projection of locking lever
3. Installing cover (Fig. 10, 11)
WARNING
Be sure to install the cover in its designated
location.
Failure to heed this warning may result in injury
from flying stones.
NOTE
Use the supplied Allen wrench 4mm for
installation.
(1) Use the supplied D5 tapping screw to install the
knife in the cover. (Fig. 10)
Knife
Cover
D5 tapping screw
(2) Align the two holes in the cover bracket and the
cover and insert two M6 × 25 hex. socket button
bolts. (The cover bracket is installed in the motor
case.)
(3) Place the cover holder on the underside of the
cover and use the supplied Allen wrench 4 mm to
alternately tighten the two M6 × 25 hex. socket
button bolts until they are properly tightened.
(Fig. 11)
Lock
Fig. 9
Fig. 10