Nylon Head - Hitachi CG36DL (L) Mode D'emploi

English
Hook
Hanger
Main pipe
(2) To detach the gardening appliance from the hanger
belt, hold the main pipe with one hand and press
the release mechanism of the hanger belt from
both sides as shown in Fig. 15.
To attach the gardening appliance, insert from
below, making sure that is it properly attached.
Press
(to detach)

NYLON HEAD

Installation of semi-auto nylon head
1. Function
Automatically feeds more nylon cutting line when
it is tapped .
Specifications
Type of
Code No. Direction of
attaching
attaching rotation
screw
Female Counterclockwise M10×
335234
screw
Applicable nylon cord
Cord diameter: Fig. 16
Length: 13.12 ft. (4 m)
Cross-section shape of line: Oval
0.066 in.
(1.68 mm)
18
Release mechanism
BL36200
Fig. 14
Insert
(to attach)
Fig. 15
Size of
attaching
screw
P1.25-LH
Fig. 16
CAUTION
●
The case must be securely attached to the cover.
●
Check the cover, case and other components for
cracks or other damage.
●
Check the case and button for wear.
If the wear limit mark on the case is no longer
visible or there is a hole in the bottom of the
button, change the new parts immediately.
(Fig. 17)
●
The nylon head must be securely mounted to the
threaded fastener of the motor case.
●
For outstanding performance and reliability,
always use Hitachi nylon cutting line. Never use
metal wire rope and the like that could become a
dangerous projectile.
●
If the nylon head does not feed cutting line
properly, check that the nylon line and all
components are properly installed. Contact your
Hitachi dealer if you need assistance.
2. Installation (Fig. 18, 19)
(1) Insert the flange assy into the motor case. At this
time, the wing of the flange assy should face the
motor case side. Next, align the holes of the flange
assy and the motor case, insert the Allen wrench 4
mm, and then turn to tighten the flange assy.
(2) Screw the nylon head directly to the threaded
fastener of the motor case.
Flange ass'y
Wing
Motor Case
Button
Wear
limit
mark
Fig. 17
Fig. 18