Burner Cap Placement - Thermador PRO GRAND PRD36 Guide D'utilisation

Electronic Single Point Ignition
Burner Base Burner Base Burner Base
Figure 14: STAR Burner Components
®
Each STAR burner has its own electronic igniter that
sparks when the burner is turned on. Each burner
should light in 4 seconds or less. If a burner does not
light, check to see that the burner cap is positioned
correctly on the base (see Figure 15 and Figure 16).
CAUTION:
DO NOT touch the STAR burners when the igniters are
sparking.
English 14
If a burner fails to ignite, refer to "Before Calling For Service"
on page 40.
Automatic Re-Ignition
If any one or more burners blow out, the electronic igniter
automatically activates to re-light the flame. DO NOT touch
the STAR burners when the igniters are active.
IMPORTANT:
• For proper combustion, DO NOT use the cooktop
Igniter Igniter Igniter
without the burner grates in place.
• There is a slight sound associated with gas combustion
and ignition. This is normal.
Figure 13: Igniter
On cooktops using propane (LP) gas, a slight "pop" sound
may be heard from the STAR burner ports a few seconds
after the burner has been turned off.
Burner Cap Burner Cap Burner Cap

Burner Cap Placement

The burner caps must be properly placed on the STAR
burner bases for the cooktop to function properly. If the
burner cap is not properly placed, one or more of the
following problems may occur.
• Burner flames are too high.
• Flames shoot out of burners.
Igniter Igniter Igniter
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
To prevent flare-ups and avoid the creation of harmful
by-products, do not use the cooktop without all burner
caps and all burner grates properly positioned.
To prevent burns, do not touch burner caps or grates
while hot. Turn the cooktop off and allow the burners to
cool.
WARNING:
WARNING: