Offset Feature; Using The Sabbath Mode - Thermador PRO GRAND PRD36 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. When the actual probe temperature reaches the
desired set temperature, the cooking mode will be
finished and the "end of cook timer" will beep to
indicate that the cooking process has concluded. The
oven turns itself off automatically when the meat probe
temperature has been reached.
Probe Care and Use
To avoid damaging your probe, DO NOT pull on the
cable when trying to remove it from a dish.
DO NOT use tongs or other instruments to pry on the
probe when removing it or to "hammer" the probe into a
food dish.
DO NOT wash the probe in the dishwasher; use warm,
soapy water instead to clean it.
To prevent possible burns, wait until the oven has
cooled before trying to remove the probe from the
outlet.
DO NOT store the probe inside the oven.
Minimum Internal Cooking Temperatures
The minimum internal temperatures that foods must
reach to be considered safe to eat, as determined by the
U. S Department of Agriculture Food Safety and
Inspection Service, are as follows:
Fresh ground beef, veal, lamb, pork
Beef, veal, lamb roasts, steaks, chops
Medium rare
Medium
Well done
Fresh pork roasts, steaks, chops
Medium
Well done
Ham
Cook before eating
Fully cooked, to reheat
Poultry
Ground chicken, turkey
Whole chicken, turkey
Breasts, roasts
Thighs and wings
Stuffing (cooked alone or in bird)
Egg dishes, casseroles
Leftovers
English 24
Using the Offset Feature
The Offset feature allows the cook to further fine-tune their
cooking parameters to their own personal optimal settings
by allowing them to adjust the temperature offset of the
oven by +/-25°F (14°C) in increments of 5°F. For example,
if the cook judges the oven temperature as too hot and
wants to lower it by 5°F, press the "–" button. To increase
the temperature by 5°F, press the "+". This feature is useful
if you find that food is consistently either too brown or too
light for your tastes.
The oven must be turned off in order to set an offset
value.
The Offset feature is available for all modes except
Self-Clean.
By default, the temperature is set at 0°.
The unit will continue to run the input offset value
indefinitely until the user manually changes it, or until
the unit loses power, in which case Offset will need to
be reset.

Using the Sabbath Mode

Sabbath Mode is for faiths with "No Work" requirements on
the Sabbath. It keeps an oven on at a specified
temperature for as long as it is required. The cook can
prepare a meal prior to a holiday and then leave it in the
always-warm oven until it is ready to be eaten.
160°F (72°C)
The oven lamp is disabled in Sabbath mode to prevent
any action from occurring at any time the door is
145°F (63°C)
opened.
160°F (71°C)
The temperature in Sabbath Mode can be varied at any
170°F (77°C)
time during the cooking process.
The gas burners and griddle on the cooktop are still
160°F (72°C)
fully functional during Sabbath Mode.
170°F (77°C)
Sabbath Mode is only available when the range is not
already in another active cooking mode or Self-Clean.
160°F (72°C)
If the door is opened during preheat or during a cycle
140°F (60°C)
operation, there will be no change to the current state
of the oven. That is to say, if the bake element was on
before the door was opened, the element will remain
165°F (74°C)
on. If the element was cycled off just before the door
180°F (82°C)
was opened, it will remain off even though it would
normally cycle back on with the call for heat. The
170°F (77°C)
regular cycle will resume once the door is closed.
180°F (82°C)
165°F (74°C)
160°F (72°C)
165°F (74°C)

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Pro grand prd48

Table des Matières