O.backrest; Angle Adjustable Backrest (Optional); Q.seating And Seat Sling Upholstery; Removing The Seat Rail - Quickie QXi Manuel D'instructions

Q XI / Q X
23
O. BACKREST
1. Height Adjustment
a. Using a 10mm wrench remove fastener(A).
b. Adjust to the desired backrest height. Back height is measured with the chair in the unfolded position,
from the top of the seat sling to the highest point of the back upholstery in a vertical straight line.
c. Align the threaded insert in the upper backrest cane to the nearest hole in the frame.
d. insert fastener (A) through the frame and thread into the insert in the back cane.
NOTE– Do not use the top angle adjustment hole for adjusting the back height.
NOTE– Use a torque setting of 144 in-lbs. when adjusting the backrest.
P. ANGLE ADJUSTABLE BACKREST (Optional)
1. Angle Adjustment
a. loosen button head screws (B) until the eccentric offset washer (c) moves freely.
b. Adjust backrest to desired angle, aligning eccentric offset washer in the slot.
c. tighten button head screws.
d. Repeat for the opposite side.
2. Pivot Point Height Adjustment
a. Remove button head screw (D) from the frame.
b. Adjust backrest to obtain desired pivot point height.
c. Replace and tighten button head screws.
d. Repeat for the opposite side.
3. Backrest Height Adjustment
a. Remove button head screw (E)
b. Adjust back tube to the desired height.
c. Replace and tighten button head screw.
d. Repeat for the opposite side.
NOTE– Use a torque setting of 144 in-lbs. when adjusting the backrest
Q. SEATING AND SEAT SLING UPHOLSTERY
the seat sling can be adjusted through the use of hook and loop material beneath the seat. seat sling also
includes a folding strap on the seat to assist in folding the chair.
NOTE–the seat sling folding strap is not intended as a carrying strap.
1. Adjustment
a. Using a flathead screwdriver, remove seat rail end caps at the front of the chair (F).
b. slide the seat sling, plastic retaining rods, and spacers (if present) from the channels in the seat rails.
c. Readjust hook and loop material to obtain the desired tension in the seat sling.
d. Reinsert the seat sling and plastic retaining rods into the channels in the seat rails.
e. Replace the end caps.
R. REMOVING THE SEAT RAIL
Detach the seat rails by removing the two bolts (g) attaching the seat rail (h) to the cross brace.
24 25
26
27
IX. DEALER SERVICE AND ADJUSTMENT
25
23
A
24
pivot point
B
c
D
25
E
26
27
120346 Rev. D