Quickie QXi Manuel D'instructions page 26

Q XI / Q X
S. BACKREST TENSION ADJUSTABLE
1. To install the Backrest Tension Adjustable
a. slide Velcro straps (D) over the backrest frame (E)section. Make sure to include at least
one strap below the towel bar (if using a rigid chair).
b. tighten the straps appropriately to desired tension level. Do not overtighten straps as
this will cause undue strain upon the chair backrest frame (E).
c. if using inegral push handles (F), slide straps from bottom of backrest upward.
d. install backrest cover at desired level and fold over rear of Velcro strapping system (g).
the Quickie patch should be upright on the rear of the chair.
e. Finish installation by placing vanity flap (center panel) down onto Velcro on the seat sling
to secure attachment (h).
2. Adjusting the Backrest Tension Adjustable
suggest using anti tips while making any adjustments. Ensure anti tips are safely secured and in a
position to prevent the wheelchair from tipping backwards.
a. User can transfer into wheelchair. Place wheel locks in the locked position
b. From the rear of the wheelchair the attendant can lift the Vanity Flap (center panel) to
access the strap system. Adjust straps for optimal balance and truck alignment. Ensure the
Velcro straps has a minimum of 2"s of engagement, hook securing to loop. Press the
Velcro together to ensure it's securely engaged.
c. once adjustments have been finalized replaced Vanity Flap to its original position.
Any changes made to the straps will affect the center of gravity. suggest the user has the atten-
dant stationed behind the wheelchair to prevent the wheelchair from tipping backwards while they
become accustomed to the adjustment.
T. SIDEGUARD HARDWARE (Optional)
1. Installation of side guard hardware
a. Position outer receiver hardware (A) on frame.
b. on corresponding inside of the frame position inner clamping hardware (B)
c. insert two bolts (c) with washer(E)and tighten using 3/16 inch hex key
d. Your sideguard (D) can now be inserted into the receiver.
NOTE –After installing receiver hardware and inserting side guard check for interference. Don't operate the
wheelchair that as interference with these other components.
U. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. if you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly pre-
pared.
2. Review troubleshooting guide.
3. If your problem persists, contact your authorized supplier. If you still have a problem after contacting
your authorized supplier, contact Sunrise customer service. See the introduction page for details on
how to contact your authorized supplier or Sunrise customer service.
120346 Rev. D
28 29 30
WARNING
31
26
IX. DEALER SERVICE AND ADJUSTMENT
c
B
28
29
30
31
D
E